How to extend the service life of aluminum alloy doors and windows?
Maintenance of aluminum alloy doors and windows
To ensure that the cleaning is in use, the action should be as light as possible. Do not use too much force. If there are any obstacles when the door or window is opened, it should be eliminated first. To maintain the cleanliness of the door frame, especially the cleaning of the push-pull slot, the dust collected in the push-pull slot can easily cause difficulties in pushing and pulling the aluminum alloy doors and windows, resulting in easy damage to the doors and windows, thereby affecting the service life of the doors and windows.
cleaning method
1, often scrub aluminum doors and windows, keep the surface clean, not to be contaminated and corroded, in the scrub when possible choose soft gauze or cotton, etc., so as not to scratch the surface of doors and windows.
2. Rub the glass with a towel or warm vinegar to remove the dirt from the glass.
3, the glass first painted chalk gray water or gypsum powder, after wiping with a dry cloth, you can clean the glass.
4, put some water in the basin, pour a few shampoo mix, use it to clean the glass, it will be clean and bright.
5, the scale on the glass, wipe with a cloth or toothpaste, wipe clean, bright clean hall.
6, take a dry one wet two pieces of cloth, first wipe the glass on both sides with a damp cloth; then use a dry cloth to pick up a few white wine, rub the glass with force, you can clean and bright.
7. If there is a pen on the glass, it can be rubbed with a rubber soaked in water and wiped with a damp cloth.
8, stained with paint on the glass, available cotton turpentine, hot vinegar to wipe.
9, when you wipe the window, put some blue enamel in the water, will add the gloss of the glass.
10. It is very clean to wipe the glass with stockings and water.
Anti-corrosion to avoid acidic, alkaline chemicals contact with the surface of aluminum alloy doors and windows, in the presence of stains and dirt, soft cloth can be used to clean water or neutral detergent to prevent corrosion of doors and windows.
Accessories maintenance
1. If it is found that the seal tops and glass glue fall off, repair and replace them in time to ensure the sealing and heat insulation of the aluminum doors and windows. Dry the glass and window frame promptly after it rains.
2. Check the connection parts of the door and window frame, tighten the bolts in time, and replace the damaged parts. Positioning pins, wind bracing, floor springs and other vulnerable parts of aluminum alloy doors and windows, should be checked from time to time, regularly add oil to keep clean and flexible.
3, check the aluminum door and window frame wall joints, aluminum doors and windows once loose, easy to make the frame as a whole deformation, so that doors and windows can not be closed, sealed. Therefore, the screws loose at the connection should be tightened immediately. For example, the screw base is loose, and a small amount of cement is sealed by applying epoxy glue.
4, check the various types of hardware accessories sliding doors and windows, if found damaged in time to repair or replace, chute with a long time, you can apply a little wax or oil drops of oil, reduce friction, keep the doors open and close Easy and flexible.
